Cleaning for On-The-Go Operations


For cleaning the fibers for on-the-go operations, hold a pocket comb or soft brush lightly against the the MicroFingers® fibers while the machine is running. Repeat this process as you start to see the fibers clog up and begin laying over.

Cleaning Pads After Each Use


Always clean pads immediately after use. Waxes that are designed to give a quick shine, like a spray-on/wipe-off wax can be cleaned from the pad using dish soap. For better quality waxes, using a dish soap can take too long. We recommend that you use either Greased Lightning™ or Simple Green®. Rinse the pad thoroughly and squeeze out the excess moisture. Pat dry with a towel, then allow the pad to air dry. Place the pad(s) in a plastic bag or back in the original package to protect them for future use.

For oil-based cleanup, use mineral spirits. Apply the mineral spirits to a rag and wipe the MicroFingers® fibers until clean. Some discoloration will remain in the glue layer, but the key is to clean the fibers.

Greased Lightning™ and Simple Green® products are available at most home improvement centers and mass merchandising outlets.

Greased Lightning™ is a registered trademark of A&M Cleaning Products, Inc.
Simple Green® is a registered trademark of Sunshine Makers, Inc.

4301 Chimney Lake Drive • Roswell, GA 30075 • USA

:: Contact Customer Service ::

:: Site Map ::

 

© Copyright 2003. All Rights Reserved

.